Wiki Navigation
- Loading...
This section is only visible in expert mode. |
If you have the PowerDVD decoder v10+ installed configuration for the codec will appear in MediaPortal.
Setup
Installation
You need to manually register the PowerDVD decoders or they will not be listed below the Codecs and Renderer node. To register the different PowerDVD decoders you need to open a command prompt as Administrator and run the following commands (make sure you use the correct PowerDVD version in the path):
H.264/VC-1/MPEG Video Decoder
regsvr32 "C:\Program Files (x86)\CyberLink\PowerDVD12\Common\VideoFilter\CLCvd.ax"
MPEG-2 and H.264 Video Decoders
regsvr32 "C:\Program Files (x86)\CyberLink\PowerDVD12\Common\VideoFilter\CLVsd.ax"
Audio Decoder
regsvr32 "C:\Program Files (x86)\CyberLink\PowerDVD12\Common\AudioFilter\Claud.ax"
Enabling PowerDVD Codec
You also need to select PowerDVD as audio or video decoders under Video Codecs, to use this codec for playback.
Settings
- Use DXVA -
- Use HAM -
- Use SW -
- De-interlace Options (to Deinterlace Video content, best choice is Auto-Select). Disable this option if you use DXVA.
Video
Audio
- Speaker Environment -
- Output Mode -
This page has no comments.